Your water heater is one pretty used and much more costly appliances in your home, and consumes a large involving your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving from the home heating as well as costs.

Regular flushing of the water heater is among the single most important step you get to prolong its service life in addition, it save energy. In a period of time, sediments enhance in the bottom of your water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. This is not merely destructive to the tank, but highly inefficient and will significantly raise your heating costs.

In most involving the country, the standard water heater lasts 3-5 years. Regularly flushing your water heater can double daily life of your water heater from 3-5 to 7-10 years. Something else costs of replacement running from $700 to over $1200 in some cases, getting the most out of your heater ‘s very important in today’s economy. In addition, regular flushing makes your hot water heater run more efficiently and can cut heating costs fifty percent. Depending on the volume of warm water your home uses, that can mean a savings of $20 to over $50 a fair amount of time.

To drain your water heater, on the internet should set the thermostat to pilot (if it is a gas water heater) or turn the circuit breaker off (if it can be an electric heater). Failure to do so could result in overheating and severe damage to drinking water heater. Next, close the water supply valve located on the water inlet line going into your water heater. You can then connect a garden hose to the drain valve located towards the end of the hot water heater. Open the drain and allow it to function until all of the water has emptied from the heater. Then close the drain. Open the water supply valve and refill the heater tank. You should also open a hot water faucet somewhere inside and stand there and watch it run for several minutes until the water flows out smoothly. This will allow air to vent inside heater and the water lines. Finally, you can turn the thermostat to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).

Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system to your residence to filter or condition the water so may be less corrosive to your plumbing system, particularly in areas possess hard wetness. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in location to discuss options and merchandise to fit the bill.

Abacus Plumbing, Air Conditioning & Electrical

The Woodlands, TX

(281) 528-1610

https://goo.gl/maps/Fccz1JjKrjN2

Central heating system and Air Solutions: Heating and cooling Maintenance for Homeowners

You May Also Like